Blank Cover Image

Cavity filling analysis in injection molding: Case studies

著者名:
Stanton, Kathy ( Husky Injection Molding Systems, Limited )  
掲載資料名:
SME technical paper series
発行年:
1992
通号:
CM92-264
ペーパー番号:
CM92-264
開始ページ:
1P
出版情報:
Society of Manufacturing Engineers
ISSN:
01616382
言語:
英語
資料種別:
テクニカルペーパー

類似資料:

1 テクニカルペーパー Filling a Specific Shaped Cavity with a Thermoplastic Polymer by Injection Molding: Relations with Mechanical Properties

Benoit-Cervantes,Geraldine

Society of Automotive Engineering, Inc.
7 テクニカルペーパー Volatile Organic Compounds (VOCs) in Ambient Air - A Case Study at the Vicinity of Fuel Filling Stations in New Delhi, India

Neeraj Kumar, Prashant Kumar, M. Sithananthan, Reji Mathai, Ajay Kumar Sehgal

Society of Automotive Engineers
2 テクニカルペーパー Filling a Specific Shaped Cavity with a Thermoplastic Polymer by Injection Molding: Relations with Mechanical Properties

Benoit-Cervantes, Geraldine

Society of Automotive Engineers
8 テクニカルペーパー Brake Judder Analysis: Case Studies

Abdelhamid,Mohamed Khalid

Society of Automotive Engineers
3 テクニカルペーパー Cavity Fill Balancing Technique for Rubber Injection Molding

Terry Lynn Chapin, Van Thomas Walworth

Society of Automotive Engineers
9 テクニカルペーパー Design, analysis and making of molds for injection molding using solid modeling

Sundaram, R. Meenakshi, Dickens, Tim W.

Society of Manufacturing Engineers
4 テクニカルペーパー Evaluation of a Piezoelectric Energy Extraction Device for Cavity Pressure Sensing in Injection Molding.

Theurer, C. B., Zhang, L., Kazmer, D., Gao, R. X.

American Society of Mechanical Engineers
10 テクニカルペーパー Analysis of injection/compression liquid composite molding process variants

Phelan, Frederick R. Jr.

The American Society of Mechanical Engineers
5 テクニカルペーパー Design of Experiments Case Study of a Transfer Molding Process.

Hassan, S.

Society of Manufacturing Engineers
11 テクニカルペーパー Application of FEA Simulations in Plastic Injection Molding Tooling Failure Analysis

Zhang, Yi, Mahmood, Nasir, Siddiqui, Abdul S., Usman, Mohammad

Society of Automotive Engineering, Inc.
6 テクニカルペーパー Numerical Simulation of Polymer Flow Control for a Multi-Cavity Mold During Injection Molding Processes.

Pinarbasi, A., Layser, G. S., Coulter, J. P.

American Society of Mechanical Engineers
12 テクニカルペーパー Application of FEA Simulations in Plastic Injection Molding Tooling Failure Analysis.

Zhang, Y., Mahmood, N., Siddiqui, A.S., Usman, M.

Society of Automotive Engineers
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12