Local heat/mass transfer measurements in a rectangular duct with discrete ribs

Local heat/mass transfer measurements in a rectangular duct with discrete ribs

著者名:

Cho, H. H. ( Yonsei University )
Wu, S. J.
Kwon, H. J.

掲載資料名:

A.S.M.E. paper

シリーズ名:

ASME Technical Paper : GT

シリーズ巻号:

1999

発行年:

1999

通号:

99-GT-121

ペーパー番号:

99-GT-121

出版情報:

New York: The American Society of Mechanical Engineers

言語:

英語

請求記号:

A11800

資料種別:

テクニカルペーパー

詳細

TDL書誌ID:	ZA00002782
シリーズID:	PA00000136
会議名:	International Gas Turbine & Aeroengine Congress & Exhibition
回次:	1999
会議開催地:	Indianapolis, Indiana
会議開催年:	1999.06.07-1999.06.10
論文注記:	Presented at the International Gas Turbine & Aeroengine Congress & Exhibition Indianapolis, Indiana - June 7-June 10, 1999 This paper has been accepted for publication in the Transactions of the ASME Discussion of it will be accepted at ASME Headquarters until September 30, 1999

類似資料:

1 テクニカルペーパー The Combined Effects of Rib Arrangements and Discrete Ribs on Local Heat/Mass Transfer in a Square Duct. Cho, H.H., Lee, S.Y., Wu, S.J. American Society of Mechanical Engineers	7 テクニカルペーパー Effects of Rib Turbulator on Heat/Mass Transfer for Impingement/Effusion Cooling with Crossflow Rhee, D., Nam, Y., Cho,H. American Institute of Aeronautics and Astronautics
2 テクニカルペーパー An Investigation of Duct Aspect Ratio Effects on Heat/Mass Transfer in a Rotating Duct with 90° Ribs. Kim, K. M., Kim, Y. Y., Rhee, D. H., Cho, H. H. American Society of Mechanical Engineers	8 テクニカルペーパー Heat (mass) transfer and film cooling effectiveness with injection through discrete holes part I: Within holes and on the back surface Cho, H. H., goldstein. R. J. The American Society of Mechanical Engineers
3 テクニカルペーパー Heat/Mass Transfer Measurement within a Film Cooling Hole of Square and Rectangular Cross Sections. Cho, H.H., Kang, S.G., Rhee, D.H. American Society of Mechanical Engineers	9 テクニカルペーパー Heat (mass) transfer and film cooling effectiveness with injection through discrete holes part II: On the exposed surface Cho, H. H., Goldstein. R. J. The American Society of Mechanical Engineers
4 テクニカルペーパー Numerical Simulation of Flow and Heat Transfer in a Duct with Square Ribs and Bleed Holes Gu, X., Wu, H., Shen, S., Shih, T. American Institute of Aeronautics and Astronautics	10 テクニカルペーパー Computation of Flow and Heat Transfer in Rotating Rectangular Channels (AR=4) with V- Shaped Ribs by a Reynolds Stress Turbulence Model. Su, G., Teng, S., Chen, H-C., Han, J-C. American Society of Mechanical Engineers
5 テクニカルペーパー Local Heat/Mass Transfer with Various Rib Arrangements in Impingement/Effusion Cooling System with Crossflow. Rhee, D. H., Nam, Y. W., Cho, H. H. American Society of Mechanical Engineers	11 テクニカルペーパー Heat Transfer in Millimeter Scale Two Phase Catalytic Reactor Lee, D.H., Cho, J., Kwon, S. American Institute of Aeronautics and Astronautics
6 テクニカルペーパー Effects of Bleed Flow on Heat/Mass Transfer in a Rotating Rib-Roughened Channel. Jeon, Y.H., Park, S.H., Kim, K.M., Lee, D.H., Cho, H.H. American Society of Mechanical Engineers	12 テクニカルペーパー Effects of Hole Arrangements on Local Heat/Mass Transfer for Impigement/Effusion Cooling with Small Hole Spacing. Cho, H. H., Rhee, D. H., Goldstein, R. J. American Society of Mechanical Engineers

1

2

3

4

5

6

7

8

9

10

11

12