Modelling of Strain Rate and Temperature Dependent Flow Stresses of Supercooled Austenite for AISI 4140

Modelling of Strain Rate and Temperature Dependent Flow Stresses of Supercooled Austenite for AISI 4140

著者名:

掲載資料名:

Physical and numerical simulation of materials processing VII : selected, peer reviewed papers from the 7th International Conference on Physical and Numerical Simulation of Materials Processing (ICPNS'13), June 16-19, 2013, Oulu, Finland

シリーズ名:

Materials science forum

シリーズ巻号:

762

発行年:

2013

開始ページ:

122

終了ページ:

127

総ページ数:

6

出版情報:

Aedermannsdorf, Switzerland: Trans Tech Publications

ISSN:

02555476

言語:

英語

請求記号:

M23650

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00054240
シリーズID:	PA00000012
会議名:	International Conference on Physical and Numerical Simulation of Materials Processing (ICPNS'13)
回次:	7th
会議開催地:	Oulu, Finland
会議開催年:	2013.06.16-2013.06.19
論文注記:	7th International Conference on Physical and Numerical Simulation of Materials Processing (ICPNS'13), June 16-19, 2013, Oulu, Finland

類似資料:

1 国際会議録 Residual Stress Depth Distribution after Piezo Peening of Quenched and Tempered AISI 4140 F. Lienert, J. Hoffmeister, V. Schulze Trans Tech Publications	7 国際会議録 Time-and temperature-dependent stress-strain analysis using white-light photoviscoelasticity Yoneyama,S., Takashi,M., Gotoh,J. SPIE-The International Society for Optical Engineering
2 国際会議録 Austenite-Bainite Transformation Kinetic Model for the Powder-Metallurgical Steel Astaloy 85 Mo P. Nusskern, J. Hoffmeister, V. Schulze Trans Tech Publications	8 国際会議録 Transformation Behavior of Supercooled Austenite during Hot Deformation of Plain Medium Carbon Steel within (γ+α) 2-Phase Field at a Low Strain Rate K.H. Kim, J.H. Chung, J.K. Park Trans Tech Publications
3 国際会議録 Local Residual Stress Distributions Induced by Repeated Austenite-Martensite Transformation via Laser Surface Hardening of Steel AISI 4140 V. Kostov, J. Gibmeier, A. Wanner Trans Tech Publications	9 国際会議録 Strain Rate Dependence and Short-Term Relaxation Behavior of a Thermoset Polymer at Elevated Temperature: Experiment and Modeling A. J. W. McClung, M. B. Ruggles-Wrenn American Society of Mechanical Engineers
4 国際会議録 Residual Stress Stability and Alternating Bending Strength of AISI 4140 after Shot Peening and Successive Annealing Menig, R., Schulze, V., Vohringer, O. Trans Tech Publications	10 国際会議録 Determining a Flow Stress Model for High Temperature Deformation of Ti-6Al-4V E. Calvert, J. Pollard, M. Jackson, B. Wynne, R. Thackray Trans Tech Publications
5 国際会議録 Generation and Determination of Compressive Residual Stresses of Short Penetration Depths R. Weingärtner, J. Hoffmeister, V. Schulze Trans Tech Publications	11 国際会議録 Measurement of Strain Rate-Dependent Material Properties for Polymers Keuerleber, M., Eyerer, P., Buhring, J. Society of Plastics Engineers
6 国際会議録 The temperature and strain rate dependence of the flow stress in MoSi2 single crystals Maloy, S. A., Mitchell, T. E., Petrovic, John J., Heuer, A. H., Lewandowski, J. J. MRS - Materials Research Society	12 国際会議録 Constitutive Modeling of Stress-Strain Curves of IF Austenite R.E. Lino, R. Barbosa Trans Tech Publications

1

2

3

4

5

6

7

8

9

10

11

12