Neutron Diffraction Measurement and Finite Element Modelling of Residual Strains Due to Bath and Spray Quenching of AISI 316L Stainless Steel Cylinders

Neutron Diffraction Measurement and Finite Element Modelling of Residual Strains Due to Bath and Spray Quenching of AISI 316L Stainless Steel Cylinders

著者名:

掲載資料名:

Stress evaluation in materials using neutrons and synchrotron radiation : selected peer reviewed papers from the International Conference on Stress Evaluation in Materials Using Neutrons and Synchrotron Radiation proceedings, Vienna, 24 - 26 September 2007

シリーズ名:

Materials science forum

シリーズ巻号:

571-572

発行年:

2008

開始ページ:

137

終了ページ:

142

総ページ数:

6

出版情報:

Aedermannsdorf, Switzerland: Trans Tech Publications

ISSN:

02555476

言語:

英語

請求記号:

M23650

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00054118
シリーズID:	PA00000012
会議名:	International Conference on Stress Evaluation in Materials Using Neutrons and Synchrotron Radiation
回次:	2007
会議開催地:	Vienna, Austria
会議開催年:	2007.09.24-2007.09.26
論文注記:	International Conference on Stress Evaluation in Materials Using Neutrons and Synchrotron Radiation proceedings, Vienna, 24 - 26 September 2007

類似資料:

1 国際会議録 Residual Stress in Laser Bent Steel Components Topic, M., Bucher, R., Vorster, W.J.J., Zhang, S.Y., McGrath, P., Korsunsky, A.M. Trans Tech Publications	7 国際会議録 Effect of Residual Stresses on Mechanical Properties of Duplex Stainless Steel Studied by Diffraction and Self-Consistent Modelling Dakhlaoui, R., Braham, C., Baczmanski, A., Wronski, S., Wierzbanowski, K., Oliver, E.C. Trans Tech Publications
2 国際会議録 A Study of Residual Elastic Strain Distribution in an AZ91 Mg Alloy Bar Loaded in Four Point Bending D.G. Leo Prakash, W.J.J. Vorster, S.Y. Zhang, A.M. Korsunsky Trans Tech Publications	8 国際会議録 Residual Strain Measurement by Synchrotron Diffraction Withers, P.J., Preuss, M., Webster, P.J., Hughes, D.J., Korsunsky, A.M. Trans Tech Publications
3 国際会議録 Oxford HEXameter: Laboratory High Energy X-Ray Diffractometer for Bulk Residual Stress Analysis Korsunsky, A.M., Zhang, S.Y., Dini, D., Vorster, W.J.J., Liu, J. Trans Tech Publications	9 国際会議録 Residual Stress Evaluation of Carburized Transmission Steel Gear Using Neutron and Synchrotron X-Ray Diffraction and Finite Element Methods Y. Sakaida, T. Serizawa, M. Kawauchi, M. Manzanka Trans Tech Publications
4 国際会議録 Neutron Diffraction Analysis of Stresses in an In-Plane Biaxially-Fatigued Stainless Steel Sample of Cruciform Geometry Yu.V. Taran, A.M. Balagurov, J. Schreiber, A.M. Korsunsky Trans Tech Publications	10 国際会議録 Residual Stress Measurement and Verification of Quenched Steel Based on Neutron Diffraction Method Ju, D.Y., Mukai, R., Minakawa, N., Narazaki, M. Trans Tech Publications
5 国際会議録 Inter-Granular Residual Stresses in Polycrystalline Aggregates: Finite Element Modelling and Diffraction Post-Processing X. Song, S.Y. Zhang, D. Dini, A.M. Korsunsky Trans Tech Publications	11 国際会議録 Strain-Induced Martensitic Phase Transformation by Low-Cycle Fatigue in AISI 316L Stainless Steel Y.C. Jeon, C.S. Kim, H. Ki, S.I. Kwun, J.W. Byeon Trans Tech Publications
6 国際会議録 Simulation of Stress and Residual Stresses due to Gas Quenching of AISI 52100 Steel Cylinders Kubler, R., Muller, H., Lohe, D. Trans Tech Publications	12 国際会議録 Influence of Laser Parameters on Residual Stress Field of AISI 304 Stainless Steel Induced by Laser Peening: A Finite Element Analysis Ling Xiang, Weiwei Peng American Society of Mechanical Engineers

1

2

3

4

5

6

7

8

9

10

11

12