Influence of Work Material Properties on Residual Stresses and Work Hardening Induced by Machining

Influence of Work Material Properties on Residual Stresses and Work Hardening Induced by Machining

著者名:

掲載資料名:

Residual stresses VII : ECRS 7 : proceedings of the 7th European conference on residual stresses, Berlin, Germany, 13-15 September 2006

シリーズ名:

Materials science forum

シリーズ巻号:

524-525

発行年:

2006

開始ページ:

575

終了ページ:

580

総ページ数:

6

出版情報:

Switzerland: Trans Tech Publications

ISSN:

02555476

ISBN:

9780878494149 [0878494146]

言語:

英語

請求記号:

M23650

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00015828
シリーズID:	PA00000012
会議名:	European Conference on Residual Stresses
回次:	7th
会議開催地:	Berlin, Germany
会議開催年:	2006.09.13-2006.09.15

類似資料:

1 国際会議録 Experimental and FEM Analysis of Cutting Sequence on Residual Stresses in Machined Layers of AISI 316L Steel Outeiro, J.C., Umbrello, D., M'Saoubi, R. Trans Tech Publications	7 国際会議録 Influence of Stacking Fault Energy on the Mechanical Properties and Work Hardening Behavior of Ultra-Fine (UF) Grained Cu and Cu Alloys P. Yang, H. Yang, J.M. Tao, C.J. Li, L. Shen Trans Tech Publications
2 国際会議録 Residual Stress after EDM ? FEM Study and Measurement Results Rebelo, J.C., Kornmeier, M., Batista, A.C., Dias, A.M. Trans Tech Publications	8 国際会議録 Influence of the Interaction Potential Parameters on the Mechanical Response of Simulated Semi-Crystalline Polymeric Materials Simoes, R., Viana, J.C., Dias, G.R., Cunha, A.M. Trans Tech Publications
3 国際会議録 Surface Integrity of H13 ESR Mould Steel Milled by Carbide and CBN Tools Marques, M.J., Outeiro, J.C., Dias, A.M., Saoubi, R.M., Chandrasekaran, H. Trans Tech Publications	9 国際会議録 The Influence of Work Hardening, Internal Stresses, and Stress Relaxation on Ductility of Ultrafine Grained Materials Prepared by Severe Plastic Deformation D.G. Morris, M.A. Muñoz-Morris, I. Gutierrez-Urrutia Trans Tech Publications
4 国際会議録 Effect of Detector Width and Peak Location Technique on Residual Stress Determination in Case of Work-Hardened Materials Belassel, M., Bocher, E., Pineault, J. Trans Tech Publications	10 国際会議録 Evaluation of Welding Residual Stresses Using the Incremental Hole-Drilling Technique Nobre, J.P., Loureiro, A., Batista, A.C., Dias, A.M. Trans Tech Publications
5 国際会議録 Combining Case Hardening and Shot Peening for Gear Steels: Influence on Residual Stresses Peyrac, C., Flavenot, J. F., Convert, F. Trans Tech Publications	11 国際会議録 Laser Hardening Parameters Influencing Component Lifetime and Residual Stresses S. Němeček, M. Męšek, I. Černý, J. Sís, N. Ganev Trans Tech Publications
6 国際会議録 Residual Stresses in Decorative Electroplated Coatings Pina, J., Dias, A.M., Lebrun, J.-L. Trans Tech Publications	12 国際会議録 Depth and Lateral Variation of Machining-Induced Residual Stress for a Nickel Base Superalloy W. Li, P.J. Withers, M. Preuss, J. Shackleton, P. Andrews Trans Tech Publications

1

2

3

4

5

6

7

8

9

10

11

12