Blank Cover Image

New Method of Designing Runner System for Injection Mold Using CAO Technique

著者名:
掲載資料名:
ANTEC 2004, 62nd annual technical conference, Chicago, IL, May 16-20, 2004
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
62
発行年:
2004
開始ページ:
3438
終了ページ:
3442
総ページ数:
5
出版情報:
Brookfield Center, Conn.: Society of Plastics Engineers
ISBN:
9780975370704 [0975370707]
言語:
英語
請求記号:
S42700/62-3
資料種別:
国際会議録

類似資料:

1 国際会議録 A New Approach Of Parts Designfor FMVSS201U Using Simple Deformation Model and CAO Technique (624)

Hirota,T., Togawa,Y.

Society of Plastic Engineers.
7 国際会議録 Designing Runners to Control Gas Distribution in Gas-Assist Injection Molding (1194)

Pollack,T., Miller,G.

Society of Plastic Engineers.
2 テクニカルペーパー A Method to Design Plastic Part for Impact Energy Absorption by Optimizing both Material Property and Part Structure.

Togawa, Y., Hirota, T.

Society of Automotive Engineers
8 国際会議録 Methodial Designing of Molds for Injection Molding of Polymers

Raos P., Catic I.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 A General Method of Designing Injection Molds by Straightforward Solution Procedures

Rao, N.S., Schumacher, G., Schott, N.R.

Society of Plastics Engineers
9 国際会議録 In-service dispersion monitoring technique using ditheres-filter method and its application to fast adaptive compensation in reconfigurable optical networks …

Takushima Y., Hirota Y., Yoshiara K.

SPIE - The International Society of Optical Engineering
4 国際会議録 A Method for Balancing Runner Systems in Asymmetrical Transfer Molds

Heinle, P. J.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Automated design for the runner system of injection molds based on packing simulation

Lee, B.H., Kim, B.H.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Anisotropic Impact Properties of Injection-Molded Polypropylene

Cao B., Sullivan T., Charwinsky S., Sugg H.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 True 3D Flow Analysis for Designing Hot and Cold Runners in Injection Molds

Haylett, R. J., Rhoades, D. W.

Society of Plastics Engineers
6 国際会議録 Runner Diameter and Length Effects on Molded-in Stresses of Injection Molded Parts

Cleveland, S.R., Latchaw, J.P.

Society of Plastics Engineers
12 国際会議録 Designing Premature Failure out of Injection Molded Parts

Mehta, K. S.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12