Usefulness of Numerical Injection Molding Simulation Results for Prediction of Mechanical Behavior of Plastics Components (823)
- 著者名:
- Koster,R. ( Delft University of Technology )
- 掲載資料名:
- ANTEC 2002, annual technical conference, San Francisco, CA, May 5-9, 2002
- シリーズ名:
- Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
- シリーズ巻号:
- 60
- 発行年:
- 2002
- 巻:
- 3
- 開始ページ:
- 2987
- 終了ページ:
- 2991
- 総ページ数:
- 5
- 出版情報:
- Brookfield, Conn.: Society of Plastic Engineers.
- ISBN:
- 9780971643505 [0971643504]
- 言語:
- 英語
- 請求記号:
- S42700/60
- 資料種別:
- 国際会議録
類似資料:
1
国際会議録
Prediction of Mechanical Properties of Injection Molded Plastics Components - A Systems Approach
Society of Plastics Engineers |
Society of Plastics Engineers, Inc. (SPE) |
2
国際会議録
Status of Research on Design for Mechanical Reliability of Injection Molded Plastics products
Society of Plastics Engineers |
Society of Plastics Engineers, Inc. (SPE) |
3
国際会議録
Status of Research on Design for Mechanical Reliability of Injection Molded Plastics products
Society of Plastics Engineers |
Society of Plastics Engineers, Inc. (SPE) |
4
国際会議録
Status of Research on Design for Mechanical Reliability of Injection Molded Plastics Products
Society of Plastics Engineers |
Society of Plastics Engineers |
5
国際会議録
Importance of Injection Molding Parameters for Mechanical Performance of Cold Flow Weld Lines
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers |