Blank Cover Image

A Transparent Barrel for Study of Reciprocating Screw Injection Molding

著者名:
掲載資料名:
ANTEC 2000 Conference proceedings, May 7-11, 2000, Orlando, Florida
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
46
発行年:
2000
パート:
1
開始ページ:
523
終了ページ:
527
総ページ数:
5
出版情報:
Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
ISBN:
9781566768559 [1566768551]
言語:
英語
請求記号:
S42700/46
資料種別:
国際会議録

類似資料:

1 国際会議録 Solid-Bed Break-Up During Plastication in Injection Molding (604)

Jin,Z., Gao,F.

Society of Plastic Engineers.
7 国際会議録 An Experimental Analysis of Injection Molding Melt Temperature

Zhao C., Gao F.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 Reciprocating-Screw Injection Molding Machine for Microcellular Foam

Xu, J., Pierick, D.

Society of Plastics Engineers
8 国際会議録 Study of Water-Debinding for Ceramic Parts by Injection Molding

Z.P. Xie, L.L. Wang, X.F. Yang

Trans Tech Publications
3 国際会議録 Experimental Study of Vented Barrel Injection Molding

Hemmati M., Nunn E. R.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Intermittent Extrusion Blow Molding Using a Reciprocating Screw

Mancine, N. A.

Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 Velocity Analysis in Recovery Process for Reciprocating-Screw of Injection Molding

Xu, J.

Society of Plastics Engineers
10 国際会議録 Intermittent Extrusion Blow Molding Using a Reciprocating Screw

Mancine, N. A.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 An On-Line Measurement Scheme of Melt-Front-Area during Injection Filling via a Soft-Sensor Implementation

Chen, X., Gao, F.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 Study of Polymer Melt Flow during Injection Molding Using Co-Injection Molding Technique

Chen, S. C., Hsu, K. F., Jung, W. R.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 A Study on Computer Simulation of Plastic Lens Molding Process

Li, W., Jin, Y. F., Lv, X., Kua, C. H.

Trans Tech Publications
12 国際会議録 Multi-VariableInteraction Analysis and a Proposed Quality Control System for Thermoplastics Injection Molding

Gao F., Yang Y.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12