Blank Cover Image

A Numerical Virtual Process Modeler Based on Computer Aided Engineering Software for Injection Molding

著者名:
掲載資料名:
ANTEC '99 Conference proceedings, New York City, May 2-6, 1999 : plastics bridging the millennia
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
45(1)
発行年:
1999
巻:
1
開始ページ:
680
終了ページ:
684
総ページ数:
5
出版情報:
Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
ISBN:
9781566768047 [1566768047]
言語:
英語
請求記号:
S42700/45-1
資料種別:
国際会議録

類似資料:

1 国際会議録 COMPUTER-AIDED ENGINEERING (CAE) FOR INJECTION MOLDING OF PLASTICS

Wang, K. K.

American Institute of Chemical Engineers
7 国際会議録 Computer-Aided Cooling-system Design for Injection Molding

Kwon H. T., Wang K. K.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 Computer Aided Engineering Design of Powder Injection Molding Process for a Dental Scaler Tip Mold Design

C.J. Hwang, Y.B. Ko, H.P. Park, S.T. Chung, B.O. Rhee

Trans Tech Publications
8 国際会議録 Injection Molding Process Control Based on Empirical Models

Ricketson, R., C., Wang, K. K.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Computer-Aided Design Software for Cooling System in Injection Molding

Himasekhar K., Hieber A. C., Wang K. K.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Computer Aided part Cost Analysis for Injection Molding

Busch, J., Field, F. III

Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 Computer-Aided-Engineering for the Gas-Assisted Injection Molding Process

Turng, L. S.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Skeleton-based 3D computer-aided detection of colonic polyps

Wang, Z., Li, L., Li, X., Liang, Z., Harrington, D.P.

SPIE-The International Society for Optical Engineering
5 国際会議録 Development of an Integrated Computer-Aided Engineering and Optimization System for Injection Molding (660)

Peic,M., Turng,L-S.

Society of Plastic Engineers.
11 国際会議録 Numerical Simulation of Co-Injection Molding

Wang, J.

Society of Plastics Engineers
6 国際会議録 Adaptive On-Line Process Control of Injection Molding Using PVT Model

Wang, P. J.

Society of Plastics Engineers, Inc. (SPE)
12 国際会議録 Numerical Simulation of the Sequential Filling in Injection Molding Process

Gao, D. M., Nguyen, K. T., Girard, P., Salloum, G.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12