Blank Cover Image

An Approach Towards Molding Parts with Constant Properties on Addition of Regrind

著者名:
掲載資料名:
ANTEC 94 : plastics : gateway to the future : conference proceedings, San Francisco May 1-5 1994 : Volume III. Special areas
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
40(3)
発行年:
1994
巻:
3
開始ページ:
3037
終了ページ:
3041
総ページ数:
5
出版情報:
Brookfield, CT: Society of Plastics Engineers, Inc. (SPE)
言語:
英語
請求記号:
S42700/941470
資料種別:
国際会議録

類似資料:

1 国際会議録 An Approach Towards Molding Parts with Constant Properties on Addition of Regrind

Dontula, N., Campbell, G. A., Wenskus, J. J.

Society of Plastics Engineers, Inc. (SPE)
7 国際会議録 Transfer Point Control Comparison Between Mold Parting Line and the Standard Strategies

Wenskus, J.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 A Novel Approach to Determine Melt Temperature Profiles in Injection Molding

Dontula N., Campbell A. G., Wenskus J. J.

Society of Plastics Engineers, Inc. (SPE)
8 国際会議録 Effect Molding Conditions on Properties of Rubber Filled Polystyrene

Campbell A. G., Devanathan H.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Melt Conveying in Extruders

Dontula N,, Campbell A. G.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 An Approach to Couple Mold Design and On-line Control to Manufacture Complex Composite Parts by Resin Trasfer Molding

Lawrence, J.M., Advani, S.G., Devillard, M.

Society of Plastics Engineers
4 国際会議録 An Experimental Study of Polymer-Filler Redistribution in Injection Molded Parts

Dontula, N., Ramesh, N. S., Campbell, G. A., Fricke, A. L., Small, J. D. Jr.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Off-line optimization of the injection molding process considering regrinds

Kuhmann, K., Ehrenstein, G.W.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 The Effect of Injection Molding Parameters on the Properties of Molded Parts

Campbell A. G., Devanathan H., Settlemire S., Sweeney P., Klewicki K., Kenny T., Small D. J., Fricke L. A.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 Blow Molding Virgin and Regrind Polymers with Titanates and Zirconates-2001

Monte, S. J.

Society of Plastics Engineers
6 国際会議録 Fluid Flow and Particle Trajectories in Single Screw Pumps and Extruders

Campbell A. G., Hunt D., Dontula N., Dunn S.

Society of Plastics Engineers, Inc. (SPE)
12 国際会議録 MOLDING THICK WALLED PARTS

Keegan, J. F.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12