Blank Cover Image

Using Compuer Software Analysis with Gas Assist Injection Molded Parts

著者名:
Hotchkiss W. J. ( Penn State Erie, The Behrend College )  
掲載資料名:
Conference proceedings at ANTEC '98 : plastics on my mind, Society of Plastics Engineers, Atlanta, Georgia, April 26-April 30, 1998
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
44(1)
発行年:
1998
巻:
1
開始ページ:
3355
終了ページ:
3359
総ページ数:
5
出版情報:
Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
ISBN:
9781566766692 [1566766699]
言語:
英語
請求記号:
S42700/44-1
資料種別:
国際会議録

類似資料:

1 国際会議録 Using Computer Software Analysis with Gas Assist Injection Molded Parts

Hotchkiss, J. W.

Society of Plastics Engineers, Inc. (SPE)
7 国際会議録 Cover Part as an Application Example for Gas-Assisted Injection Molded Parts

Hansen, M.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 Using Computer Software Analysis with Gas Assist Injection Molded Parts

Hotchkiss W. J.

Society of Plastics Engineers, Inc. (SPE)
8 国際会議録 Cover Part as an Application Example for Gas-Assisted Injection Molded Parts

Hanse, M.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Structural Analysis, process Si,ulation and Warpage Calculation for the Gas-Assisted Injection Molded Parts Using a Unified CAE Model

Chen C. S., Hu Y. S., Jong R. W., Jeng C. M.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Non-Destructive Product Characterization of Gas Bubbles in Gas-Assisted Injection-Molded Parts

Lu, X., Fong L., Chiang H. H.

Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 Influence of Processing Parameter on Quality of Gas-Assisted-Injection-Molded Parts

Yang, S. Y., Liou, S. J.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Shrinkage Analysis of Molded Parts Using Neural Network

Lee C. S., Baek H. J., Youn R. J.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Case Studies of the Gas-Assisted Injection Molded Parts Designed with a Gas Channel of Different Geometry

Chen C. S., Hsu S. K., Liu L. W., Chen C. Y., Ho K. K.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 Preventing Sink Marks of Injection Molded Parts Using CAE Analysis

Ni, S.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Analysis of Internal Structure of Injection-Molded parts Based on a Three-Deimensional Simulation Software

Hoffmann, S., Michaeli, W.

Society of Plastics Engineers
12 国際会議録 Off-Line Quality Analysis of Injection Molded Parts Using Experimental Design

Henza Don, Lipowicz Loretta

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12