Blank Cover Image

Injection molding of plastic optics:the basics

著者名:
Hoff,A.M. ( U.S.Precision Lens )  
掲載資料名:
Optical Engineering Midwest '95
シリーズ名:
Proceedings of SPIE - the International Society for Optical Engineering
シリーズ巻号:
2622
発行年:
1995
巻:
Part1
開始ページ:
147
終了ページ:
150
出版情報:
Bellingham, Wash.: SPIE-The International Society for Optical Engineering
ISSN:
0277786X
ISBN:
9780819419866 [0819419869]
言語:
英語
請求記号:
P63600/2622
資料種別:
国際会議録

類似資料:

1 国際会議録 Basic considerations for injection molding of plastic optics

Hoff,A.M.

SPIE-The International Society for Optical Engineering
7 国際会議録 The Effect of Mold Surface Topography on Plastic Part In-Process Shrinkage in Injection Molding

Theilade, U.R., Kjaer, E.M., Norgaard Hansen, H.

Society of Plastics Engineers
2 国際会議録 Injection molding for diffractive optics

R.D. TeKolste, W.H. Welch, M.R. Feldman

Society of Photo-optical Instrumentation Engineers
8 国際会議録 Passive fiber alignment to single-mode plastic waveguides fabricated by injection molding

Pompe,G., Lehmacher,S., Rudolph,S., Kalveram,S., Johnck,M., Neyer,A.

SPIE-The International Society for Optical Engineering
3 国際会議録 New challenges for adaptive optics:the OWL 100-m telescope

Hubin,N.N., Louarn,M.Le, Sarazin,M.S., Tokovinin,A.A., Viard,E.

SPIE - The International Society for Optical Engineering
9 国際会議録 Importance of experimentation on teaching the basics of optics from elementary to high school

Costa,M.F.M.

SPIE-The International Society for Optical Engineering
4 国際会議録 New and Autoadaptative Process Control on Plastic Injection Molding

Devos, P., Laurent, F., Pabiot, J., Ryckebusch, M.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Injection molding higher performance reinforced plastic composites

Rosato, D.V.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Radiation impact on spaceborne optics:the dose coefficients approach

Fruit,M., Gusarov,A.I., Doyle,D.B., Ulbrich,G.J.

SPIE - The International Society for Optical Engineering
11 国際会議録 CIM: Successfully Automating the Plastic Injection Molding Process

Gerlitz, F.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 New Virtual Environment for Active Learning on Parameter Adjustment of Plastic Injection Molding

J.J. Marquez, M. Rodriguez, M.L. Martinez, J.M. Perez

Trans Tech Publications
12 国際会議録 Three-Dimensional Simulation of Plastic Injection Molding

Talwar K., Costa F., rajupalem V., Antanovsi L., Friedl C.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12