Blank Cover Image

The effect of coolant flow rate on cooling in machining

Author(s):
Li, Xiaoping ( National University of Singapore )  
Publication title:
SME technical paper series
Pub. Year:
1995
No.:
MR95-134
Paper no.:
MR95-134
Page(from):
1P
Pub. info.:
Society of Manufacturing Engineers
ISSN:
01616382
Language:
English
Type:
Technical Paper

Similar Items:

1 Technical Paper Modelling chip formation along the tool-chip interface in machining

Li, Xiaoping

Society of Manufacturing Engineers
7 Technical Paper Study on Boiling Heat Transfer and Critical Heat Flux in Mist Cooling (Effect of Air Flow Rate on Heat Transfer and Behavior of Liquid on Heating Surface).

Ohtake, H., Koizumi, Y.

American Society of Mechanical Engineers
2 Technical Paper Minimization of coolant mass flow rate in internally cooled gas turbine blades

Martin, Thomas J., Dulikravich, George S., Han, Zhen-Xue, Dennis, Brian H.

The American Society of Mechanical Engineers
8 Technical Paper Measurements Over A Film-Cooled, Contoured Endwall With Various Coolant Injection Rates.

Oke, R., Simon, T., Shih, T., Zhu, B., Lin, Y.L.

American Society of Mechanical Engineers
3 Technical Paper Effect of coolant temperature and mass flow on film cooling of turbine blades

Garg, Vijay K., Gaugler, Raymond E..

The American Society of Mechanical Engineers
9 Technical Paper Numerical Simulation of Film Cooling in Reactive Flow over a Surface with Shaped Coolant Hole

C. Lin, R. Holder, H. Thornburg, B. Sekar, J. Zelina, W. Anderson, M. Polanka

American Institute of Aeronautics and Astronautics
4 Technical Paper Comparison of the Cooling Performance of Cylindric and Fan-Shaped Cooling Holes with Special Emphasis on the Effect of Internal Coolant Cross-Flow.

Saumweber, C., Schulz, A.

American Society of Mechanical Engineers
10 Technical Paper Influence of Coolant Gas Properties on Film Cooling Effectiveness in High Enthalpy Flows

M. Mizoguchi, S. Aso, Y. Tani

American Institute of Aeronautics and Astronautics
5 Technical Paper Optimization of the Exhaust Mass Flow Rate and Coolant Temperature for Exhaust Gas Recirculation (EGR) Cooling Devices Used in Diesel Engines.

Charles, F.L.R., Ewing, D., Becard, J., Chang, J-S., Cotton, J.S.

Society of Automotive Engineers
11 Technical Paper Modelling The Air-Cooled Gas Turbine Part 2 - Coolant Flows and Losses.

Youg, J.B., Wilcock, R.C.

American Society of Mechanical Engineers
6 Technical Paper Effect of Exhaust Catalysts on Regulated and Unregulated Emissions from Low Temperature Diesel Combustion with High Rates of Cooled EGR.

Li, T., Izumi, H., Shudo, T., Ogawa, H.

Society of Automotive Engineers
12 Technical Paper Use of Simulation Tools with Integrated Coolant Flow Analysis for the Cooling System Design

Eichlseder,W., Raab,G., Hager,J., Raup,M.

Society of Automotive Engineers
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12