Parametric studies of ultrasonic machining

Parametric studies of ultrasonic machining

Author(s):

Seah, K.H.W. ( National University of Singapore )
Wong, Y.S.
Lee, L.C.

Publication title:

SME technical paper series

Pub. Year:

1990

No.:

MR90-294

Paper no.:

MR90-294

Page(from):

1P

Pub. info.:

Society of Manufacturing Engineers

ISSN:

01616382

Language:

English

Type:

Technical Paper

Details

TDL ID:	ZA00004078
Note for article:	Submitted for Publication at SME September 1990

Similar Items:

1 Technical Paper Machinability of hiduminium/Corundum particulate composites Seah, K.H.W., Kulkarni, R.S., Sharma, S.C., Ramachandra, A. Society of Manufacturing Engineers	7 Technical Paper Analysis and computation of nonlinear dynamic response of a two-degree-of-freedom system and its application in aeroelasticity Lee, B.H.K., Gong, L., Wong, Y.S. American Institute of Aeronautics and Astronautics
2 Technical Paper The benefits of using titanium nitride coated tools in the deep drawing of aluminum cups Seah, K.H.W., Lee, K.S. Society of Manufacturing Engineers	8 Technical Paper Experimental Study on Cutting Temperature in Rotary Ultrasonic Machining. Cong, W.L., Treadwell, C. Society of Manufacturing Engineers
3 Technical Paper Mechanical properties of aluminum/Silocon carbide particulate composites Seah, K.H.W., Sharma, S.C. Society of Manufacturing Engineers	9 Technical Paper Micro Machining of Silicon by Electrical Discharge machining. Liu, W., Rahman, M., Wong, Y.S. Society of Manufacturing Engineers
4 Technical Paper Corrosion characteristics of case al-zn-mg alloys Seah, K.H.W., Sharma, S.C. Society of Manufacturing Engineers	10 Technical Paper Liquid Elyback Booster Pre-Phase A Study Assessment Pererson, W., Ankney, W., Bell, J., Berning, M., Bryant, L., Bufkin, A., Cain, L., Caram, J., Cockrell, B., Curry, D., … National Aeronautics and Space Adminstration
5 Technical Paper Ultimate tensile strength and fracture toughness of sub-zero chilled cast iron Seah, K.H.W., Hemanth, J., Sharma, S.C. Society of Manufacturing Engineers	11 Technical Paper An Experimental Study of Heat and Mass Transfer in Fiber Coating Process. Liu, C.S.L., Lee, S.H.-K. American Institute of Aeronautics and Astronautics
6 Technical Paper A comparison between the corrosion characteristics of solid and porous titanium in NaCl solution Seah, K.H.W., Chen, X. Society of Manufacturing Engineers	12 Technical Paper High Performance Machining of Sculptured Surfaces Using Pencil-Cut machining and Material Side Tracing. Ren, Y., Lee, Y.S., Zhu, W. Society of Manufacturing Engineers

1

2

3

4

5

6

7

8

9

10

11

12