Mathematical Modeling of the In-Mold Coating Process for Injection Molded Thermoplastic Parts (718)
- Author(s):
- Chen,X. ( The Ohio State University )
- Castro,J.M. ( ONMOVA Solutions Inc. )
- Straus,E.J.
- Publication title:
- ANTEC 2002, annual technical conference, San Francisco, CA, May 5-9, 2002
- Title of ser.:
- Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
- Ser. no.:
- 60
- Pub. Year:
- 2002
- Vol.:
- 1
- Page(from):
- 614
- Page(to):
- 618
- Pages:
- 5
- Pub. info.:
- Brookfield, Conn.: Society of Plastic Engineers.
- ISBN:
- 9780971643505 [0971643504]
- Language:
- English
- Call no.:
- S42700/60
- Type:
- Conference Proceedings
Similar Items:
Society of Plastics Engineers |
Society of Plastics Engineers |
Society of Plastics Engineers |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers |
Society of Plastics Engineers, Inc. (SPE) |
American Institute of Chemical Engineers |
5
Conference Proceedings
Optimizing Injection Gate Location and Cycle Time for the In-mold Coating (IMC) Process
Society of Plastics Engineers |
11
Conference Proceedings
Structural Analysis, process Si,ulation and Warpage Calculation for the Gas-Assisted Injection Molded Parts Using a Unified CAE Model
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers |
12
Conference Proceedings
Modelling and Simulation of Thermally Induced Stress and Warpage in Injection Molded Thermoplastics
Society of Plastics Engineers, Inc. (SPE) |