Blank Cover Image

Methodial Designing of Molds for Injection Molding of Polymers

Author(s):
Publication title:
Plastics create a world of difference : conference proceedings : ANTEC 89, New York, May 1-4, 1989, Society of Plastics Engineers 47th Annual Technical Conference & Exhibits
Title of ser.:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
Ser. no.:
35
Pub. Year:
1989
Page(from):
1248
Page(to):
1250
Pages:
3
Pub. info.:
Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
Language:
English
Call no.:
S42700/890581
Type:
Conference Proceedings

Similar Items:

1 Conference Proceedings A General Method of Designing Injection Molds by Straightforward Solution Procedures

Rao, N.S., Schumacher, G., Schott, N.R.

Society of Plastics Engineers
7 Conference Proceedings New Method of Designing Runner System for Injection Mold Using CAO Technique

Nagaoka, S., Hirota, T., Togawa, Y.

Society of Plastics Engineers
2 Conference Proceedings Injection Molding of Degradable Interference Screws into Polymeric Mold

Á. Oroszlany, P. Nagy, J.G. Kovács

Trans Tech Publications
8 Conference Proceedings Degradation of Polymers During Injection Molding

Nguyen T. K., Weber L., Hebert P. L.

Society of Plastics Engineers, Inc. (SPE)
3 Conference Proceedings Quick Mold Change for Injection Molding Machines

Glorio, P.

Society of Plastics Engineers, Inc. (SPE)
9 Conference Proceedings Advanced Methods for Monitoring Injection Molding Process II: Multicavity Molds

Souder V. B., Whitehall L. B., Davis E. J.

Society of Plastics Engineers, Inc. (SPE)
4 Conference Proceedings Considerations in the Roughness of the Molds Surface and the Molded Parts Utilized in Injection Molding. (289)

Pereira,A., Hernandez,P.

Society of Plastic Engineers.
10 Conference Proceedings A New Method for Simulation of Injection Molding

Yu, H., Cook, P., Kietzmann, C., Costa, F., Xu, S., Kennedy, P.

Society of Plastics Engineers
5 Conference Proceedings designing for thinwall injection molding

Oehler, Peter R.

Society of Plastics Engineers, Inc. (SPE)
11 Conference Proceedings Improving Impact Strength of Injection Molded Plates through Molding Conditions

Viana C. J., Kearney P., Cunha M. A.

Society of Plastics Engineers, Inc. (SPE)
6 Conference Proceedings The Effect of Injection Molding Parameters on the Properties of Molded Parts

Campbell A. G., Devanathan H., Settlemire S., Sweeney P., Klewicki K., Kenny T., Small D. J., Fricke L. A.

Society of Plastics Engineers, Inc. (SPE)
12 Conference Proceedings Design and Development of Injection Molded FRP Crank Chain Wheel Assebmly for a Bicycle

Gupta, A., Misra, A., Mittal, R. K., Rao, P. N.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12