Planned Maintenance of Injection Molds Increases Productivity

Planned Maintenance of Injection Molds Increases Productivity

Author(s):

Michaeli W. ( Institut fur Kunststoffverarbeitung )
Feldhaus A.

Publication title:

ANTEC 93 : Be in that number : conference proceedings : New Orleans, May 9-13, 1993

Title of ser.:

Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers

Ser. no.:

39

Pub. Year:

1993

Vol.:

1

Page(from):

2825

Page(to):

2833

Pages:

9

Pub. info.:

Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)

Language:

English

Call no.:

S42700/932082

Type:

Conference Proceedings

Details

TDL ID:	ZA00018300
Series ID:	PA00000030
Conf. info. (Name):	ANTEC '93 : Annual Technical Conference
Conf. info. (Number):	51st
Conf. info. (Venue):	New Orleans, LA, USA
Conf. info. (Date):	1993.05.09-1993.05.13
Note for article:	INJECTION MOLDING DIVISION

Similar Items:

1 Conference Proceedings Procedures for Increasing the Weldline Strength of Injection Molded Parts Michaeli W., Galuschka S. Society of Plastics Engineers, Inc. (SPE)	7 Conference Proceedings Repair and Maintenance of Injection Molds Moberg C. Society of Plastics Engineers, Inc. (SPE)
2 Conference Proceedings Analysis od Injection Molded Microatructures Rogalla A., Michaeli W. Society of Plastics Engineers, Inc. (SPE)	8 Conference Proceedings RIM-Process Technique and Mold Design Kotte R., Michaeli W. Society of Plastics Engineers, Inc. (SPE)
3 Conference Proceedings Micro Assembly Injection Molding-Mold and Processing Technology Ziegmann, C., Michaeli, W. Society of Plastics Engineers	9 Conference Proceedings Improvement of the Molded Part Quality-Optimization of the Plastification Unit Boelinger, S., Michaeli, W. Society of Plastics Engineers, Inc. (SPE)
4 Conference Proceedings Automatic Application of Ribs in Product Design to Increase the Stiffness of Injection-Moulded Parts Stojek, M., Michaeli, W. Society of Plastics Engineers, Inc. (SPE)	10 Conference Proceedings Increasing Quality by Online Control of the Cavity Pressure Michaeli, W., Gruber, J. Society of Plastics Engineers
5 Conference Proceedings Temperature Distribution in Rapid Tooling Cavities-How Close Are Injection Molded Prototypes to Series Parts? Langen M., Michaeli W. Society of Plastics Engineers, Inc. (SPE)	11 Conference Proceedings On-Line Prediction of Molded Part Properties in RIM-Processing by Control of Cavity Pressure Henze E., Michaeli W. Society of Plastics Engineers, Inc. (SPE)
6 Conference Proceedings Analysis of Internal Structure of Injection-Molded parts Based on a Three-Deimensional Simulation Software Hoffmann, S., Michaeli, W. Society of Plastics Engineers	12 Conference Proceedings Infrared Temperature Measurements - Measured and Calculated Temperature Profiles in the Cavity of a Mold Bluhm R., Michaeli W. Society of Plastics Engineers, Inc. (SPE)

1

2

3

4

5

6

7

8

9

10

11

12