Blank Cover Image

Injection molding of plastic optics:the basics

Author(s):
Hoff,A.M. ( U.S.Precision Lens )  
Publication title:
Optical Engineering Midwest '95
Title of ser.:
Proceedings of SPIE - the International Society for Optical Engineering
Ser. no.:
2622
Pub. Year:
1995
Vol.:
Part1
Page(from):
147
Page(to):
150
Pub. info.:
Bellingham, Wash.: SPIE-The International Society for Optical Engineering
ISSN:
0277786X
ISBN:
9780819419866 [0819419869]
Language:
English
Call no.:
P63600/2622
Type:
Conference Proceedings

Similar Items:

1 Conference Proceedings Basic considerations for injection molding of plastic optics

Hoff,A.M.

SPIE-The International Society for Optical Engineering
7 Conference Proceedings The Effect of Mold Surface Topography on Plastic Part In-Process Shrinkage in Injection Molding

Theilade, U.R., Kjaer, E.M., Norgaard Hansen, H.

Society of Plastics Engineers
2 Conference Proceedings Injection molding for diffractive optics

R.D. TeKolste, W.H. Welch, M.R. Feldman

Society of Photo-optical Instrumentation Engineers
8 Conference Proceedings Passive fiber alignment to single-mode plastic waveguides fabricated by injection molding

Pompe,G., Lehmacher,S., Rudolph,S., Kalveram,S., Johnck,M., Neyer,A.

SPIE-The International Society for Optical Engineering
3 Conference Proceedings New challenges for adaptive optics:the OWL 100-m telescope

Hubin,N.N., Louarn,M.Le, Sarazin,M.S., Tokovinin,A.A., Viard,E.

SPIE - The International Society for Optical Engineering
9 Conference Proceedings Importance of experimentation on teaching the basics of optics from elementary to high school

Costa,M.F.M.

SPIE-The International Society for Optical Engineering
4 Conference Proceedings New and Autoadaptative Process Control on Plastic Injection Molding

Devos, P., Laurent, F., Pabiot, J., Ryckebusch, M.

Society of Plastics Engineers, Inc. (SPE)
10 Conference Proceedings Injection molding higher performance reinforced plastic composites

Rosato, D.V.

Society of Plastics Engineers, Inc. (SPE)
5 Conference Proceedings Radiation impact on spaceborne optics:the dose coefficients approach

Fruit,M., Gusarov,A.I., Doyle,D.B., Ulbrich,G.J.

SPIE - The International Society for Optical Engineering
11 Conference Proceedings CIM: Successfully Automating the Plastic Injection Molding Process

Gerlitz, F.

Society of Plastics Engineers, Inc. (SPE)
6 Conference Proceedings New Virtual Environment for Active Learning on Parameter Adjustment of Plastic Injection Molding

J.J. Marquez, M. Rodriguez, M.L. Martinez, J.M. Perez

Trans Tech Publications
12 Conference Proceedings Three-Dimensional Simulation of Plastic Injection Molding

Talwar K., Costa F., rajupalem V., Antanovsi L., Friedl C.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12