Blank Cover Image

Basic considerations for injection molding of plastic optics

Author(s):
Hoff,A.M. ( U.S.Precision Lens )  
Publication title:
Design, fabrication, and applications of precision plastic optics : 23-24 October, 1995, Philadelphia, Pennsylvania
Title of ser.:
Proceedings of SPIE - the International Society for Optical Engineering
Ser. no.:
2600
Pub. Year:
1995
Page(from):
2
Page(to):
5
Pub. info.:
Bellingham, Wash., USA: SPIE-The International Society for Optical Engineering
ISSN:
0277786X
ISBN:
9780819419644 [0819419648]
Language:
English
Call no.:
P63600/2600
Type:
Conference Proceedings

Similar Items:

1 Conference Proceedings Injection molding of plastic optics:the basics

Hoff,A.M.

SPIE-The International Society for Optical Engineering
7 Conference Proceedings Injection molding higher performance reinforced plastic composites

Rosato, D.V.

Society of Plastics Engineers, Inc. (SPE)
2 Conference Proceedings Injection molding for diffractive optics

R.D. TeKolste, W.H. Welch, M.R. Feldman

Society of Photo-optical Instrumentation Engineers
8 Conference Proceedings CIM: Successfully Automating the Plastic Injection Molding Process

Gerlitz, F.

Society of Plastics Engineers, Inc. (SPE)
3 Conference Proceedings New and Autoadaptative Process Control on Plastic Injection Molding

Devos, P., Laurent, F., Pabiot, J., Ryckebusch, M.

Society of Plastics Engineers, Inc. (SPE)
9 Conference Proceedings Three-Dimensional Simulation of Plastic Injection Molding

Talwar K., Costa F., rajupalem V., Antanovsi L., Friedl C.

Society of Plastics Engineers, Inc. (SPE)
4 Conference Proceedings New Virtual Environment for Active Learning on Parameter Adjustment of Plastic Injection Molding

J.J. Marquez, M. Rodriguez, M.L. Martinez, J.M. Perez

Trans Tech Publications
10 Conference Proceedings On the PVT and Thermal Shrinkage for the Injection Molding of a Plastic Lens

Chang -Y. R., Hsieh -C. Y., Hsu -H. C.

Society of Plastics Engineers, Inc. (SPE)
5 Conference Proceedings The Effect of Mold Surface Topography on Plastic Part In-Process Shrinkage in Injection Molding

Theilade, U.R., Kjaer, E.M., Norgaard Hansen, H.

Society of Plastics Engineers
11 Conference Proceedings Polymer-Bound Plasticizer for Injection Molding Applications

Montanye, J. R.

Society of Plastics Engineers, Inc. (SPE)
6 Conference Proceedings Passive fiber alignment to single-mode plastic waveguides fabricated by injection molding

Pompe,G., Lehmacher,S., Rudolph,S., Kalveram,S., Johnck,M., Neyer,A.

SPIE-The International Society for Optical Engineering
12 Conference Proceedings Automated Plastication Setup for Injection Molding Machines (567)

Bakharev,A.S., Speight,R.G., Thomas,A.R.

Society of Plastic Engineers.
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12