Predictions of Transient Fuel Spray Phenomena in the Intake Port of a Si-Engine

Predictions of Transient Fuel Spray Phenomena in the Intake Port of a Si-Engine

著者名:

Burger, M. ( Institut fuer Thermische Stroemungsmaschinen, Universtitaet Karlsruhe )

掲載資料名:

Spark Ignition and Compression Ignition Engine Modeling ; San Diego, California, October 21-24, 2002

シリーズ名:

SAE special publication

シリーズ巻号:

SP1720

発行年:

2002

通号:

2002-01-2695

ペーパー番号:

2002-01-2695

開始ページ:

9

終了ページ:

20

総ページ数:

12

出版情報:

Society of Automotive Engineering, Inc.

ISBN:

9780768010893 [0768010896]

言語:

英語

請求記号:

S10350/SP1720

資料種別:

テクニカルペーパー

詳細

TDL書誌ID:	ZA00001476
シリーズID:	PA00000003
会議名:	SAE Powertrain & Fluid Systems Conference & Exhibition
会議開催地:	San Diego, CA, USA
会議開催年:	2002.10.21-2002.10.24

類似資料:

1 テクニカルペーパー Predictions of Transient Fuel Spray Phenomena in the Intake Port a Si-Engine. Burger, M., Schmehl, R., Gorse, P., Dullenkopf, K., Schafer, O. Society of Automotive Engineers	7 テクニカルペーパー The Effect of Injector and Intake Port Design on In-Cylinder Fuel Droplet Distribution, Airflow and Lean Burn Performance for a Honda VTEC-E Engine Carabateas,N.E., Taylor,A.M.K.P., Whitelaw,J.H., Ishii,Kiyoshi, Yoshida,Kazuo, Matsuki,Massato Society of Automotive Engineering, Inc.
2 テクニカルペーパー An Experimental Study on Droplet Generation in Bearing Chambers Caused by Roller Bearings. Gorse, P., Dullenkopf, K., Bauer, H.-J., Wittig, S. American Society of Mechanical Engineers	8 テクニカルペーパー Experimental investigations of the temporal air-fuel mixing fluctuations and cold flow instabilities of a premixing gas turbine burner Schildmacher, K.-U., Koch, R., Wittig, S., Krebs, W., Hoffmann, S. American Society of Mechanical Engineers
3 テクニカルペーパー Influence of Operating Condition and Geometry on the Oil Film Thickness in Aero-Engine Bearing Chambers. Gorse, P., Busam, S., Dullenkopf, K. American Society of Mechanical Engineers	9 テクニカルペーパー Influence of Atomization Quality on Mixture Formation, Combustion and Emissions in a MPI-Engine Under Cold-Start Conditions, Part II. Tribulowski, J., Spicher, U., Richter, B., Dullenkopf, K., Wittig, S. Society of Automotive Engineers
4 テクニカルペーパー Evaluation of advanced two-phase flow and combustion models for predicting low emission combustors Klose, G., Schmehl, R., Meier, R., Meier, G., Koch, R., Wittig, S., Hettel, M., Leuckel, W., Zarzalis, N. American Society of Mechanical Engineers	10 テクニカルペーパー Influence of Atomization Quality on Mixture Formation, Combustion and Emissions in a MPI-Engine Under Cold-Start Conditions, Part I. Richter, B., Dullenkopf, K., Wittig, S., Tribulowski, J., Spicher, U. Society of Automotive Engineers
5 テクニカルペーパー Experimental Analysis of Air/Oil Separator Performance. Willenborg, K., Klingsporn, M., Tebby, S., Ratcliffe, T., Gorse, P., Dullenkopf, K. American Society of Mechanical Engineers	11 テクニカルペーパー Fuel Film Evaporation and Heat Transfer in the Intake Port of an S.I. Engine Shayler, P.J., Colechin, M.J.F, Scarisbrick, A. Society of Automotive Engineers
6 テクニカルペーパー The Effect of Injector and Intake Port Design on In-Cylinder Fuel Droplet Distribution, Airflow and Lean Burn Performance for a Honda VTEC-E Engine Carabateas, N. E., Taylor, A. M. K. P., Whitelaw, J. H., Ishii, Kiyoshi, Yoshida, Kazuo, Matsuki, Massato Society of Automotive Engineers	12 テクニカルペーパー Intra-Cycle Resolution of Heat Transfer to Fuel in the Intake Port of an S.I. Engine Shayler, P. J., Colechin, M. J. F., Scarisbrick, A. Society of Automotive Engineers

1

2

3

4

5

6

7

8

9

10

11

12