Mechanical Alloying of Zr-Nb5%at. Powders: Microstructural Evolution and Hydrogenation Properties

Mechanical Alloying of Zr-Nb5%at. Powders: Microstructural Evolution and Hydrogenation Properties

著者名:

掲載資料名:

Metastable and nanostructured materials III : selected, peer reviewed papers from the 3rd Workshop on Metastable and Nanostructured Materials (NANOMAT 2006) IME, Rio de Janeiro, Brazil, June 05-08, 2006

シリーズ名:

Materials science forum

シリーズ巻号:

570

発行年:

2008

開始ページ:

59

終了ページ:

64

総ページ数:

6

出版情報:

Aedermannsdorf, Switzerland: Trans Tech Publications

ISSN:

02555476

言語:

英語

請求記号:

M23650

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00054117
シリーズID:	PA00000012
会議名:	Workshop on Metastable and Nanostructured Materials (NANOMAT 2006)
回次:	3rd
会議開催地:	Rio de Janeiro, Brazil
会議開催年:	2006.06.05-2006.06.08
論文注記:	3rd Workshop on Metastable and Nanostructured Materials (NANOMAT 2006) IME, Rio de Janeiro, Brazil, June 05-08, 2006

類似資料:

1 国際会議録 Synthesis, Hydrogenation and Mechanical Milling of Pseudo-Binary Zr(Nb_xV_1-x)₂ (0≤x≤0.65) Alloys S.A. Loureiro, D. Fruchart, S. Rivoirard, D.S. dos Santos, L.M. Tavares Trans Tech Publications	7 国際会議録 Effect of Hydrogenation Pressure on Microstructure and Mechanical Properties of Ti-13Nb-13Zr Alloy Produced by Powder Metallurgy J.H. Duvaizem, G.S. Galdino, A.H.A. Bressiani, R.N. de Faria, H. Takiishi Trans Tech Publications
2 国際会議録 Diffusion-Controlled Nanocrystallization of the Fe_73.5Cu₁Nb₃Si_15.5B₇ Finemet Amorphous Alloy R.M. Ribeiro, R.S. de Biasi, D.R. dos Santos, D.S. dos Santos Trans Tech Publications	8 国際会議録 Crystallization of Fe-Based Amorphous Alloys Studied In-Situ Using Synchrotron Radiation dos Santos, D.S., dos Santos, D.R. Trans Tech Publications
3 国際会議録 Electrical, Mechanical and Microstructural Properties of Copper-Chromium-Silver-Alumina Composites Obtained by Powder Metallurgy W.A. Monteiro, J.A.G. Carrió, M.A.R. Santos, D.S. Motta, L.C.E. Silva Trans Tech Publications	9 国際会議録 Structural and Microstructural Properties of Si-C and Si-C-B Powders Obtained by High-Energy Ball Milling L.M. Ferreira, D.S. Megda, A.C. de Souza, R.F.C. Marques, E.C.T. Ramos, V.M. Chad, A.S. Ramos Trans Tech Publications
4 国際会議録 Texture Development in Nd-Fe-V Alloys by Hot Deformation in View of Permanent Magnet Properties Popa, I., Rivoirard, S., Chateigner, D., Hansen, T., Fruchart, D. Trans Tech Publications	10 国際会議録 Microstructural Investigation of the Oxide Scale on Zr-2.5Nb and Its Interface With the Alloy Substrate Benezra, V., Mangin, S., Treska, M., Spector, M., Hunter, G., Hobbs, L. W. MRS - Materials Research Society
5 国際会議録 Microstructural Characterization of 66%Co-28%Cr-6%Mo Dental Alloy Powder Obtained by High-Energy Ball Milling C. dos Santos, A.F. Habibe, D. Rodrigues, J.C. Minatti, J.F.C. Lins Trans Tech Publications	11 国際会議録 Effect of Heat Treatment on Microstructure and Mechanical Properties of Ti-13Nb-13Zr Alloy Produced by Powder Metallurgy J.H. Duvaizem, N.M.F. Mendes, J.C.S. Casini, A.H. Bressiani, H. Takiishi Trans Tech Publications
6 国際会議録 Neutron Diffraction Texture Study of NdFeB As-Cast Alloys and Magnets Rivoirard, S., Chateigner, D., de Rango, P., Fruchart, D. Trans Tech Publications	12 国際会議録 Mechanical Properties of Natural Fibers Reinforced Polymer Composites: Palm/Low Density Polyethylene J.R. Guedes, W.M. Florentino, L.M. Rodrigues, C. dos Santos, D.R. Mulinari Trans Tech Publications

1

2

3

4

5

6

7

8

9

10

11

12