Blank Cover Image

Simulating the Melting Behavior and Melt Temperature Inhomogeneity in The Injection Molding Processes

著者名:
掲載資料名:
ANTEC 2004, 62nd annual technical conference, Chicago, IL, May 16-20, 2004
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
62
発行年:
2004
開始ページ:
515
終了ページ:
518
総ページ数:
4
出版情報:
Brookfield Center, Conn.: Society of Plastics Engineers
ISBN:
9780975370704 [0975370707]
言語:
英語
請求記号:
S42700/62-1
資料種別:
国際会議録

類似資料:

1 国際会議録 The Investigation of Flow Behavior of Polymeric Melts in the Water Assisted Injection Molding

Chang, R.Y., Huang, C.T., Yang, W.H., Tsai, M.H., Lu, K.I., Liu, S.J.

Society of Plastics Engineers
7 国際会議録 The Effects of Runner Diameter on Packing of a Plastic Part with Injection Molding

Knepper, P.C.

Society of Plastics Engineers
2 国際会議録 The Effect of Elongational Viscosity on Polymer Melt Distribution in Extrusion Dies

Vlcek, J., Perdikoulias, J., Vlachopoulos, J., Tzoganakis, C.

Society of Plastics Engineers, Inc. (SPE)
8 国際会議録 Investigation of actuation behavior for microarray thermal actuator based upon electrical analysis

Tsai, C.-C., Yang, T.-H., Huang, Y.-C.

SPIE - The International Society of Optical Engineering
3 国際会議録 A Study of Coextrusion Flows in Polymer Processing

Perdikoulias, J., Vlcek, J., Vlachopoulos, J.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Geometry Influence of Reflectors for Infrared Rapid Heating on Micro-Injection Molding

Chang, P.C., Hwang, S.J.

Trans Tech Publications
4 国際会議録 Transient Melt Temperatures in Screw Injection Molding

Sukanek C. P., Campbell A. G.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 An Experimental Analysis of Injection Molding Melt Temperature

Zhao C., Gao F.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Application of a Single Screw Extruder Simulation Towards Design (436)

Vlcek,J., Perdikoulias,J.

Society of Plastic Engineers.
11 国際会議録 Control of polymer melt flow front position during the injection molding process

Speight, R.G., Hull, J.B., Coates, P.D.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Viscoelastic Melt Behavior in the Injection Molding Process

Schmidt, L. R.

Society of Plastics Engineers, Inc. (SPE)
12 国際会議録 The calibration of process window model for 55-nm node

T. H. Wu, S. Y. Huang, C. W. Huang, P. R. Tsai, C. H. Yang, I. Y. Su, B. Falch

SPIE - The International Society of Optical Engineering
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12