Influences of Plastics Material Properties on the CAE Programs for Designing Injection Molds | 東京工業大学附属図書館文献データベース

Blank Cover Image

Influences of Plastics Material Properties on the CAE Programs for Designing Injection Molds

著者名:: Palit, K. ( RCA Laboratories )
掲載資料名:: Plastics-pioneering the 21st century : conference proceedings
シリーズ名:: Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:: 33
発行年:: 1987
開始ページ:: 1493
終了ページ:: 1495
総ページ数:: 3
出版情報:: Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
言語:: 英語
請求記号:: S42700/880310
資料種別:: 国際会議録

詳細

TDL書誌ID:	ZA00020152
シリーズID:	PA00000030
会議名:	ANTEC '87 : Society of Plastics Engineers Annual Technical Conference and Exhibit
回次:	45th
会議開催地:	Los Angeles, CA, USA
会議開催年:	1987.05.04-1987.05.07
論文注記:	COMPUTERS IN THE PLASTICS INDUSTRY SPECIAL SESSION

類似資料:

1 国際会議録 Use of a CAE Mold Filling Program in Injection Molding Process Applications Palit, K. Society of Plastics Engineers, Inc. (SPE)	7 国際会議録 COMPUTER-AIDED ENGINEERING (CAE) FOR INJECTION MOLDING OF PLASTICS Wang, K. K. American Institute of Chemical Engineers
2 国際会議録 How to Assess CAE Injection Mold Packing Softwares Palit, K. Society of Plastics Engineers, Inc. (SPE)	8 国際会議録 Increased Speed to Market Using CAE Simulation for Injection Molded Plastics Parts Duff, A. L. Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 The Significance of Rheology in CAE Injection Mold Filling Softwares Palit K., Chen -J. I. Society of Plastics Engineers, Inc. (SPE)	9 国際会議録 Designing Premature Failure out of Injection Molded Parts Mehta, K. S. Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 How to Assess CAE Injection Mold Design Softwares for Production Applications Palit K., Chen -J. I. Society of Plastics Engineers, Inc. (SPE)	10 国際会議録 Predicting Warpage of Injection Molded Fiber-Reinforced Plastics Zheng R., McCaffrey N., Winch K., Yu H., Kennedy P. Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 CAE in Plastics - Material Supplier's Viewpoint Mehta K. Society of Plastics Engineers, Inc. (SPE)	11 国際会議録 Gap between mold and part and its effect on cooling of injection-molded plastics Wang, H., Prystay, M., Hetu, J.-F., Cao, B., Jen, C.K. Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Cure Behavior of Encapsulation Materials for Microelectronic Assembly of Bare IC's Palit, K. Society of Plastics Engineers, Inc. (SPE)	12 国際会議録 The Effect of High Shear Rate and Shear Duration on the Properties of Injection Molded Plastics Wheeler, P., Miller, W. S. Society of Plastics Engineers

1

2

3

4

5

6

7

8

9

10

11

12