Blank Cover Image

Impact and Fatigue Analysis of Injection Molded parts by the Finite Element Method

著者名:
掲載資料名:
Plastics-pioneering the 21st century : conference proceedings
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
33
発行年:
1987
開始ページ:
465
終了ページ:
467
総ページ数:
3
出版情報:
Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)
言語:
英語
請求記号:
S42700/880310
資料種別:
国際会議録

類似資料:

1 国際会議録 A New Method to Predict the Structural Stability of Injection Molded Parts. A Combination of Flow Simulation and Finite Element Stress Analysis Techniques

Salloum, G., Garcia-Rejon, A., Connolly, R., Lague, G.

Society of Plastics Engineers, Inc. (SPE)
7 国際会議録 Analysis on Thermal Strain of AC7A Aluminum Alloy Casting Mold for Automobile Tire by Finite Element Method

J.S. Choi, Y.K. Oh

Trans Tech Publications
2 国際会議録 Impact Analysis of Returning Spacecraft with Finite Element Method

Cui,Y., Sun,G.

Society for Experimental Mechanics
8 国際会議録 Modeling and Analysis of Residual Stresses and Deformation in Injection Molded Parts

Salloum G., Connolly R., Girard P., Hebert P. L.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Modeling of Sink Mark Formation in Cross-Rib-Reinforced Injection-Molded Plastic Parts by Localized Finite Element Shrinkage Analysis

Shi, L., Gupta, M.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Fatigue Analysis of a Motorcycle Frame System Based on a Road Test and the Finite Element Method

L. Zhang, C. Lu, A.K. Tieu

Trans Tech Publications
4 国際会議録 Comparison of Flat Thin-Shell Finite Elements for Structural Analysis of Injection-Molded Parts

Kudryavtsev L., Wang K. K.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Automatic Design Optimization Molding Simulation for Injection Molded Parts

Barton, K. S., Lin, B., Ryim, W. G.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Effects of Finite Element Meshing on Mold Filling Analysis

Engelstein, G.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 Reduction of the Vibration of a Home Air Conditioner by Finite Element Analysis and Homogenization Method

Kim,S.G., Cho,K.L., Cho,Y.S., Chang,S.K.

Society for Experimental Mechanics
6 国際会議録 The Effect of Injection Molding Parameters on the Properties of Molded Parts

Campbell A. G., Devanathan H., Settlemire S., Sweeney P., Klewicki K., Kenny T., Small D. J., Fricke L. A.

Society of Plastics Engineers, Inc. (SPE)
12 国際会議録 ESTIMATION METHODS TO DETERMINE INJECTION MOULD COSTS

Schnmitz, J., Menges, G., Schlueter, H.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12