Automotive door hardware module by gas injection molding

Automotive door hardware module by gas injection molding

著者名:

Shah, Suresh ( Delphi Interior and Lighting Systems/GM )
Juback, Glen
Sajan, Anthony
Clark, Chris

掲載資料名:

ANTEC '96 : Plastics-Racing into the Future, May 5-10, Indianapolis : conference proceedings

シリーズ名:

Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers

シリーズ巻号:

42

発行年:

1996

巻:

Vol. 3

開始ページ:

2700

終了ページ:

2706

出版情報:

Brookfield Center, CT: Society of Plastics Engineers, Inc. (SPE)

言語:

英語

請求記号:

S42700/970361

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00018810
シリーズID:	PA00000030
会議名:	ANTEC '96
回次:	54th
会議開催地:	Indianapolis, IN, USA
会議開催年:	1996.05.05-1996.05.10

類似資料:

1 テクニカルペーパー DEVELOPMENT OF A UNIQUE, GAS-INJECTION MOLDED DOOR HARDWARE MODULE FRAME Shah, Dr. Suresh, Juback, Glen, Clark, Christopher Society of Automotive Engineers	7 国際会議録 Overcoming Process Control Challenges of Gas-Assist Injection Molding Clark L. C., Williams R., Dixon S. J., Bi S. Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 An experimental study to investigate the influene of processing conditions in the gas-assisted injection molding process Kapila, Vineet, Schott, Nick R., Shah, Suresh Society of Plastics Engineers, Inc. (SPE)	8 国際会議録 Sequential Valve Gating for Thin Wall Injection Molding Comparison between Experimental Results and Filling Software Shah, R. Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Gas Injection Molding: Structural Application Shah, S. Society of Plastics Engineers, Inc. (SPE)	9 国際会議録 Sequential Valve Gating for Thin Wall Injection Molding Comparison between Experimental Results and Filling Software Shah, R. Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 Gas Injection Molding: Current Practices Shah, S. Society of Plastics Engineers, Inc. (SPE)	10 国際会議録 Applications of Gas-Assisted Injection Molding and Injection/Compression Molding in Thinwall Molding Wang, T. J., Chen, S. -C., Chiang, H. H. Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 An Evaluation of Mold Filling Analysis on an Injection Molded Exterior Product Sajan, A. T. Society of Plastics Engineers, Inc. (SPE)	11 国際会議録 The importance of pressure dependent viscosity and contraction pressure losses to injection molding CAE analysis Sherbelis, Gal, Friedl, Chris Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Experimental validation of gas-assisted injection molding simulation tools Abbatiello, Nicholas D., Gennari, Anthony A., Zuber, Peter J. Society of Plastics Engineers, Inc. (SPE)	12 国際会議録 Gas-Assisted Rubber Injection Molding Wehr, H., Haberstroh, E. Society of Plastics Engineers

1

2

3

4

5

6

7

8

9

10

11

12