Weld-Line Strength in Injection Molded PVC Parts
- 著者名:
- Merhar, C. F. ( The Ohio State University )
- Beiter, K. A.
- Ishii, K.
- 掲載資料名:
- ANTEC 94 : plastics : gateway to the future : conference proceedings, San Francisco May 1-5 1994 : Volume III. Special areas
- シリーズ名:
- Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
- シリーズ巻号:
- 40(3)
- 発行年:
- 1994
- 巻:
- 3
- 開始ページ:
- 3450
- 終了ページ:
- 3454
- 総ページ数:
- 5
- 出版情報:
- Brookfield, CT: Society of Plastics Engineers, Inc. (SPE)
- 言語:
- 英語
- 請求記号:
- S42700/941470
- 資料種別:
- 国際会議録
類似資料:
1
国際会議録
Incorporating Dimensional Requirements into Material Selection and Design of Injection Molded Parts
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
3
国際会議録
Study of Weld-Line Strength and Microstructure of Injection Molded Microcellular Parts (1020)
Society of Plastic Engineers. |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Trans Tech Publications |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers, Inc. (SPE) |
Society of Plastics Engineers |