Blank Cover Image

Influence of Processing Parameter on Quality of Gas-Assisted-Injection-Molded Parts

著者名:
掲載資料名:
ANTEC 94 : plastics : gateway to the future : conference proceedings, San Francisco May 1-5 1994 : Volume I. Processing
シリーズ名:
Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers
シリーズ巻号:
40(1)
発行年:
1994
巻:
1
開始ページ:
408
終了ページ:
410
総ページ数:
3
出版情報:
Brookfield, CT: Society of Plastics Engineers, Inc. (SPE)
言語:
英語
請求記号:
S42700/941468
資料種別:
国際会議録

類似資料:

1 国際会議録 Experimental Study of Gas-Assisted Injection Molding

Yang, S. Y., Liou, S. J.

Society of Plastics Engineers, Inc. (SPE)
7 国際会議録 Using Computer Software Analysis with Gas Assist Injection Molded Parts

Hotchkiss W. J.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 Influence on Processing on Quality in Injection-Compression-Molded Disks

Yang S., Ke M.

Society of Plastics Engineers, Inc. (SPE)
8 国際会議録 Sink Mark Study in Injection Molded Parts

Liou J. M., Ramachandra M. D., Ishii K., Hornberger L.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 Structural Analysis, process Si,ulation and Warpage Calculation for the Gas-Assisted Injection Molded Parts Using a Unified CAE Model

Chen C. S., Hu Y. S., Jong R. W., Jeng C. M.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Online Quality Monitoring and Control for Precision Injection Molded Parts

Woll, S.L.B., Cooper, D.J.

American Institute of Chemical Engineers
4 国際会議録 The Effect of Injection Molding Parameters on the Properties of Molded Parts

Campbell A. G., Devanathan H., Settlemire S., Sweeney P., Klewicki K., Kenny T., Small D. J., Fricke L. A.

Society of Plastics Engineers, Inc. (SPE)
10 国際会議録 Studies on the Influence of the Holding Pressure on the Orientation and Shrinkage of Injection Molded Parts (98)

Pontes,A.J., Oliveira,M.J., Pouzada,A.S.

Society of Plastic Engineers.
5 国際会議録 Using Computer Software Analysis with Gas Assist Injection Molded Parts

Hotchkiss, J. W.

Society of Plastics Engineers, Inc. (SPE)
11 国際会議録 Case Studies of the Gas-Assisted Injection Molded Parts Designed with a Gas Channel of Different Geometry

Chen C. S., Hsu S. K., Liu L. W., Chen C. Y., Ho K. K.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Using Compuer Software Analysis with Gas Assist Injection Molded Parts

Hotchkiss W. J.

Society of Plastics Engineers, Inc. (SPE)
12 国際会議録 Prediction of Fiber Orientation in Injection Molded Parts Considering Compressibility and Phase Change

Lee C. S., Yang Y. D., Youn R. J.

Society of Plastics Engineers, Inc. (SPE)
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12