Dynamic Cooling Design for Injection Molding

Dynamic Cooling Design for Injection Molding

著者名:

Hatch, D. ( University of Massachusetts, Amherst )
Kazmer, D.
Fan, B.

掲載資料名:

ANTEC 2001, conference proceedings, Dallas, Texas, May 6-10

シリーズ名:

Annual Technical Conference - ANTEC : Society of Plastics Engineers Annual Technical Papers

シリーズ巻号:

47

発行年:

2001

パート:

1

開始ページ:

428

終了ページ:

432

総ページ数:

5

出版情報:

Brookfield Center, CT: Society of Plastics Engineers

ISBN:

9781587160981 [1587160986]

言語:

英語

請求記号:

S42700/47

資料種別:

国際会議録

詳細

TDL書誌ID:	ZA00017839
シリーズID:	PA00000030
会議名:	ANTEC 2001
回次:	2001
会議開催地:	Dallas, TX, USA
会議開催年:	2001.05.06-2001.05.10

類似資料:

1 国際会議録 Introduction to Dynamic Feed Contro for Injection Molding Kazmer, D. O. Society of Plastics Engineers, Inc. (SPE)	7 国際会議録 Acoustic Telemetry in Injection Molding Theurer, C. B., Zhang, L., Gao, R., Kazmer, D. O. Society of Plastics Engineers
2 国際会議録 Transfer Function Development for the Injection Molding of Optical Media Hatch, D., Kazmer, D., Niemeyer, M. Society of Plastics Engineers, Inc. (SPE)	8 国際会議録 Model Predictive Control of Injection Molding Ambady, P., Kazmer, D. Society of Plastics Engineers
3 国際会議録 Simulation of Optical Media Molding Fan, B., Kazmer, D.O. Society of Plastics Engineers	9 国際会議録 Design and Validation of Self-Compensating Melt Regulator for Plastics Extrusion Kazmer, D., Gupta, D., Fan, B. Society of Plastics Engineers
4 国際会議録 A Study of Cooling for Steady-State Injection Molding Xu, H., Kazmer, D. Society of Plastics Engineers, Inc. (SPE)	10 国際会議録 Consistency of Multi Cavity Melt Control Injection Molding in a Commercial Application Kapoor D., Kazmer D. Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 Yield Maximization in Injection Molding by the Virtual Search Method Yang, D., Hatch, D., Kazmer, D., Danai, K. Society of Plastics Engineers, Inc. (SPE)	11 国際会議録 Wireless Pressure Sensor for Injection Molding Kazmer, D.O., Gao, R.X., Theurer, C.B., Zhang, L. Society of Plastics Engineers
6 国際会議録 An On-Line Quality Monitoring System for Injection Molding Kazmer, D. American Institute of Chemical Engineers	12 国際会議録 Effect of Low Temperature Shift Factor Modeling on Predicted Part Quality Fan, B., Kazmer, D.O. Society of Plastics Engineers

1

2

3

4

5

6

7

8

9

10

11

12