Blank Cover Image

Basic considerations for injection molding of plastic optics

著者名:
Hoff,A.M. ( U.S.Precision Lens )  
掲載資料名:
Design, fabrication, and applications of precision plastic optics : 23-24 October, 1995, Philadelphia, Pennsylvania
シリーズ名:
Proceedings of SPIE - the International Society for Optical Engineering
シリーズ巻号:
2600
発行年:
1995
開始ページ:
2
終了ページ:
5
出版情報:
Bellingham, Wash., USA: SPIE-The International Society for Optical Engineering
ISSN:
0277786X
ISBN:
9780819419644 [0819419648]
言語:
英語
請求記号:
P63600/2600
資料種別:
国際会議録

類似資料:

1 国際会議録 Injection molding of plastic optics:the basics

Hoff,A.M.

SPIE-The International Society for Optical Engineering
7 国際会議録 Injection molding higher performance reinforced plastic composites

Rosato, D.V.

Society of Plastics Engineers, Inc. (SPE)
2 国際会議録 Injection molding for diffractive optics

R.D. TeKolste, W.H. Welch, M.R. Feldman

Society of Photo-optical Instrumentation Engineers
8 国際会議録 CIM: Successfully Automating the Plastic Injection Molding Process

Gerlitz, F.

Society of Plastics Engineers, Inc. (SPE)
3 国際会議録 New and Autoadaptative Process Control on Plastic Injection Molding

Devos, P., Laurent, F., Pabiot, J., Ryckebusch, M.

Society of Plastics Engineers, Inc. (SPE)
9 国際会議録 Three-Dimensional Simulation of Plastic Injection Molding

Talwar K., Costa F., rajupalem V., Antanovsi L., Friedl C.

Society of Plastics Engineers, Inc. (SPE)
4 国際会議録 New Virtual Environment for Active Learning on Parameter Adjustment of Plastic Injection Molding

J.J. Marquez, M. Rodriguez, M.L. Martinez, J.M. Perez

Trans Tech Publications
10 国際会議録 On the PVT and Thermal Shrinkage for the Injection Molding of a Plastic Lens

Chang -Y. R., Hsieh -C. Y., Hsu -H. C.

Society of Plastics Engineers, Inc. (SPE)
5 国際会議録 The Effect of Mold Surface Topography on Plastic Part In-Process Shrinkage in Injection Molding

Theilade, U.R., Kjaer, E.M., Norgaard Hansen, H.

Society of Plastics Engineers
11 国際会議録 Polymer-Bound Plasticizer for Injection Molding Applications

Montanye, J. R.

Society of Plastics Engineers, Inc. (SPE)
6 国際会議録 Passive fiber alignment to single-mode plastic waveguides fabricated by injection molding

Pompe,G., Lehmacher,S., Rudolph,S., Kalveram,S., Johnck,M., Neyer,A.

SPIE-The International Society for Optical Engineering
12 国際会議録 Automated Plastication Setup for Injection Molding Machines (567)

Bakharev,A.S., Speight,R.G., Thomas,A.R.

Society of Plastic Engineers.
1
 
2
 
3
 
4
 
5
 
6
 
7
 
8
 
9
 
10
 
11
 
12