Feasibility study on oil droplet flow investigations inside aero engine bearing chambers - PDPA techniques in combination with numerical approaches

Feasibility study on oil droplet flow investigations inside aero engine bearing chambers - PDPA techniques in combination with numerical approaches

Author(s):

Gahn, A. ( Universitat Karlsruhe(T.H.) )
Kurreck, M.
Willmann, M.
Wittig, S.

Publication title:

A.S.M.E. paper

Title of ser.:

ASME Technical Paper : GT

Ser. no.:

1995

Pub. Year:

1995

No.:

95-GT-100

Paper no.:

95-GT-100

Pub. info.:

New York: The American Society of Mechanical Engineers

Language:

English

Call no.:

A11800

Type:

Technical Paper

Details

TDL ID:	ZA00002361
Series ID:	PA00000136
Note for article:	Presented at the International Gas Turbine and Aeroengine Congress & Exposition Houston, Texas - June 5-8, 1995 This paper has been accepted for publication in the Transactions of the ASME Discussion of it will be accepted at ASME Headquarters until September 30, 1995

Similar Items:

1 Technical Paper Two-phase air/oil flow in aero engine bearing chambers - Characterization of oil film flows Glahn, A., Wittig, S. The American Society of Mechanical Engineers	7 Technical Paper An Experimental Study on Droplet Generation in Bearing Chambers Caused by Roller Bearings. Gorse, P., Dullenkopf, K., Bauer, H.-J., Wittig, S. American Society of Mechanical Engineers
2 Technical Paper Prediction of the three-dimensional reacting two-phase flow within a jet-stabilized combustor Kurreck, M., Willmann, M., Wittig, S. The American Society of Mechanical Engineers	8 Technical Paper Influence of Operating Condition and Geometry on the Oil Film Thickness in Aero-Engine Bearing Chambers. Gorse, P., Busam, S., Dullenkopf, K. American Society of Mechanical Engineers
3 Technical Paper Numerical simulation of combustor flows on parallel computers: Practical limitations and practical experience Kurreck, M., Wittig, S. The American Society of Mechanical Engineers	9 Technical Paper Experimental and theoretical study of droplet vaporization in a high pressure environment Stengele, Jorg, Willmann, Michael, Wittig, Sigmar The American Society of Mechanical Engineers
4 Technical Paper Influence of high rotational speeds on heat transfer and oil film thickness in aero engine bearing chambers Wittig, S., Glahn, A., Himmelsbach, J. The American Society of Mechanical Engineers	10 Technical Paper Analysis of the oil film on the inside surface of an aero-engine bearing chamber housing Chew, John W. The American Society of Mechanical Engineers
5 Technical Paper Local and mean heat transfer coefficients along the internal housing walls of aero engine bearing chambers Glahn, A., Busam, S., Wittig, S. The American Society of Mechanical Engineers	11 Technical Paper A Numerical Study of the Flow Inside Annular Jet Pumps El Gazzar, M., Meakhail, T., Mekhail, S. American Institute of Aeronautics and Astronautics
6 Technical Paper A Numerical Model for Oil Film Flow in an Aero-Engine Bearing Chamber and Comparison with Experimental Data. Farrall, M., Simmons, K., Hibberd, S., Gorse, P. American Society of Mechanical Engineers	12 Technical Paper Numerical study of bicomponent droplet vaporization in a high pressure environment Stengele, J., Bauer, H. -J., Wittig, S. The American Society of Mechanical Engineers

1

2

3

4

5

6

7

8

9

10

11

12